WTS PLXc with red dot ACSS Griffin Mil M8






Status
Not open for further replies.
Location (City)
Henderson

mondo223

Member (9mm)
Forum Supporter
2023 Supporter
2024 Supporter
Trading Post Subscriber
Rating - 92.5%
40   3   0
#1
Hello I have this combo setup I don't need anymore.

It's the primary arms PLX c. Super nice cost about $1,300 if you find a coupon somewhere.

I have the primary arms titanium mount which was fairly pricey.

Also there's about a $500 holosun micro red dot on top of it as well.

You can also move the red dot to the rear if you needed to just take off the attachment that it's using and swap it for the back

This is a good combo that I could reuse in a different build eventually so I'm not really looking to take a huge loss on it.

The 2 Optics and the mount ended up costing me about $2,000 total.

So if someone wants to pick up this which is in great condition and not used much at all, I'll probably start it at $1100 obo

Please note, The micro red dot was threadlocked and tightened so much on this that it's going to be very hard to get it off without further stripping the little screw. Holosun will easily send you a new piece if you need it.

1000007423.jpg


1000007424.jpg


1000007420.jpg
 
Last edited:

Just an Average Joe

Well-known member (45 ACP)
Forum Supporter
2024 Supporter
Trading Post Subscriber
Rating - 100%
162   0   0
#2
Gen 1 or Gen 2?

Turret caps look like Gen 2 but length in front looks like Gen 1 - or is there a screw in sunshade ?

And which reticle?
 
Last edited:

mondo223

Member (9mm)
Forum Supporter
2023 Supporter
2024 Supporter
Trading Post Subscriber
Rating - 92.5%
40   3   0
#3
Gen 1 or Gen 2?

Turret caps look like Gen 2 but length in front looks like Gen 1 - or is there a screw in sunshade ?

And whichreticle?
That's a screw in sunshade this was the PLX compact with the ACSS reticle or whatever it's called. This would be considered Gen 2 I think because the first version was not compact this is the compact one
 
Status
Not open for further replies.